OUR COMPANY HAS BEEN ENGAGED AUTO PARTS FOR 11 YEARS

Idler Pulley-Pulley Tensioner-Belt Tensioner-Jintai Auto Parts

GUANGZHOU JINTAI AUTO PARTS CO.,LTD.

Professional Supplier Of Engine Transmissions

Location:Home > NEWS > Company News >

Tensioner Pulley Bearing Removal

Source:未知 Browse Times:TIME:2019-03-23

Eventually all bearings go bad. When your tensioner pulley does, here’s an easy way to repair it.

I saw this little tidbit from Dennis Kirban’s Inner Circle newsletter, and thought I’d pass it long…

This tip comes from Ken, out of Ohio, who did this install with our new bearing for his tensioner.

If you don’t have a press, the old bearing can be removed by laying the pulley on a hard flat surface such as a garage floor.
Using a 1 inch socket, gently tap the old bearing out with a hammer.

To install the new bearing, use a 1-1/8 inch socket and gently tap the new bearing in from the other side of the pulley. It’s important that you make sure the socket stays centered on the bearing and the bearing is squared up in the pulley as you tap it in, and that it seats all the way at the bottom.

It took only about 10 minutes to perform this task.

下一篇:Symptoms of a Bad or Failing Drive Belt Tensioner 上一篇:没有了

rtTop